Timeguard SLW360L Instrukcja Użytkownika Pobierz pdf (Strona 9)

8 9

At this position, the unit should become operative at approximately

the same level of darkness each evening. Observe the operation

of the unit. If the unit is starting to operate too early (i.e. when it is

quite light), adjust the control slightly anti-clockwise. If the unit starts

to operate too late (i.e. dusk), adjust the control slightly clockwise.

Continue to adjust until the unit operates as desired.

Once the unit is set up as desired, refit the top cover by aligning the

arrows shown on diagram E and twisting clockwise until cover is secure.

Manual Override Mode

The light can be switched ON for longer time periods by use of the

Manual Override Mode. This can be activated at night by using the

internal wall switch or circuit breaker. Switch the internal wall switch

twice (OFF/ON, OFF/ON) within 2 seconds.

The unit will now illuminate continuously until dawn or until it is

switched back into Detection Mode.

To return to Detection Mode switch the internal wall switch OFF

and then back ON again within 1 second.

Problem

• LampstaysONallthe

time at night.

• PIRkeepsactivatingfor

no reason (at random).

Solution

CoverPIRlenswithathickcloth.

If the light turns out, check detection

area for heat or reflective source.

If the light stays ON, check wiring.

See Section 3.

Turn off at the internal wall switch.

Leave for 30 seconds and turn ON again.

Leave for at least 18 minutes.

If light activates, check area for false

activation from heat, wind or

reflective source.

Troubleshooting guide

1 2 3 4 5 6 7 8 9 10 11 12

Brak uwag

Timeguard SLW360L Instrukcja Użytkownika Strona 9